
34
IMPORTANT SAFEGUARDS FOR ELECTRICAL APPLIANCES
The appliance is driven electrically. Place the appliance near a suitable wall power
socket to connect the appliance directly to a protected mains power supply with protec-
tive conductor (earth/ground) connected properly. Ensure that the voltage rating of your
mains power supply corresponds to the voltage requirements of the appliance (220-240
V, 50 Hz, AC, rated for at least 8 A). The installation of a residual current operated cir-
cuit breaker (r.c.c.b.) with a maximum rated residual operating current of 30 mA in the
supplying electrical circuit is strongly recommended. If in doubt, contact your electrician
for further information.
• Do not use multiple electrical adapters. We recommend avoiding the usage of exten-
sion cords. However, if you wish to use an extension cord, ensure that the protective
conductor is connected properly.
• Do not leave the appliance unattended while connected to the power supply. Always
immediately unplug the appliance after use and before cleaning. Always grasp the
plug when disconnecting the appliance from the power outlet.
• Always handle the power cord with care. Do not place the appliance on a power
cord. Do not let the power cord hang over the edge of the table or counter. Keep the
cable away from any hot surfaces (e.g. sealing band of the appliance). Never pull,
rip, bend, clamp, squish or knot the power cord. Attend to nobody getting caught in
loops of the power cord or pulling the appliance off the work space. When pulling
the plug always catch hold of the enclosure of the plug. Do not attempt to repair the
power cord!
• Do not place or immerse the appliance or power cord in water or any other liquid.
Do not pour or drip any liquids on the appliance or power cord. When liquids are
spilled on the appliance, immediately unplug the appliance and dry it to avoid risk of
electric shock or fire (see ›Care and cleaning‹). Do not attempt to operate the appli-
ance, when liquids are on or in the electrical section of the appliance.
• The appliance is not intended for continuous operation. Please wait approximately
30 seconds with the lid open (approximately 2 minutes with the lid closed) after each
sealing process before switching on again. For additional safety the appliance is fit-
ted with a thermal cut out. In the event of overheating (possible with room temperature
of 35 °C or more, or overvoltage of the power supply) the appliance will automati-
cally shut down to prevent damage. In this case, unplug and let the appliance cool
down for approximately 20 minutes before operating the appliance again.