29
• Take care handling the crossed-blade knife because it is very sharp.
•
Never
hold your face or other body parts over the feed chute when the motor is
running because little pieces of food could be thrown out of the feed chute.
Important Safeguards for all Electrical Appliances
• Always uncoil the line cord completely before installing the appliance.
• Place the appliance close to a power point and connect it directly without using
any extension cords to avoid additional risks of injury through fire or voltage.
• Only install the appliance in proper form secure grounding receptacle with adequate
electric power supply (alternating current; 230/240 V, 50 Hz) and ground fault circuit
interrupter. You should also install a fuse with a release current of maximum 30mA.
If necessary ask your electrician for help.
• Never pull, rip, bend, clamp, squish or knot the line cord. Pay attention to the
line cord not hanging of the table. Attend to nobody getting caught in loops of the
line cord or pulling the appliance of the work space. When pulling the plug always
catch hold of the enclosure of the plug.
Operating
Before first usage
Rinse all the units of the appliance with water that come into contact with food and clean
them with dishwashing detergent. Operate according to the instructions ´Care and
cleaning´.
This appliance is equipped with an electronic thermostat to prevent the motor from
overheating. In case of exceeding the tolerable temperature, the mincer will be shut
down automatically.
Your appliance stops operating suddenly:
1. Press the “POWER”-button to switch the appliances off.
2. Disconnect the appliance from the power supply and pull the plug of the power
cord out of the wall outlet.
3. Let the appliance cool down for 60 minutes.
4. Insert the plug of the power cord back to the wall outlet.
5. Press the “POWER”-button. The operation can be continued.
6. Press the circuit breaker button at the bottom of the appliance to turn the appli-
ance on.
7. If overheating protection system triggers very often, please contact your
authorized service center.
41406_designfleischwolfelectronicpro_manual_GermanEnglisch_neu.qxp 20.10.2009 11:00 Seite
