Clear a blocking
If the worm housing is blocked no mince comes out of the mincer while operating or the
motor stops moving automatically because of the overload protection.
ATTENTION:
If a blocking occurs turn off the appliance immediately. Clear the
problem before turning on the motor again.
1. Turn the appliance off and take the pusher out of the feed chute.
2. If the motor stopped running because of overloading, press the power button to
turn the appliance off.
3. Press the reverse button and let the motor run in reverse mode for a few seconds.
The worm will turn backwards and loosen the blockage.
ATTENTION:
If the motor does not start moving backwards immediately turn
off the appliance and pull the plug. Disassemble and clean the appliance.
4. After a few seconds in reverse mode press the on and off button. If the appliance
still does not run smooth or the blockage occurs again, turn the appliance off (pressing
the on and off button first and then the power button), pull the plug and clean the
appliance according to the instructions ´Care and Cleaning`.
Storage
Always clean the appliance before storing.
ATTENTION:
Store and use the appliance in a clean, frost free environment
where it is protected from dampness, moistness and immoderate and extraordinary
burden (such as: downfall, beat, overheating, moisture in the motor block).
Never
lay heavy or hard objects on top of the appliance.
Always assemble the appliance for storing. This way the parts are protected and
cannot get lost.
You can store the power cord coiled up in the storage place
underneath the appliance (picture A).
ATTENTION: Never
pull, rip, bend, clamp, squish or knot
the line cord.
The attachments and the adaptor disc can be stored
inside the pusher (picture B).
40
A
B
41406_designfleischwolfelectronicpro_manual_GermanEnglisch_neu.qxp 20.10.2009 11:00 Seite
