47
ASSEMBLING FOR MAKING
SAUSAGES
1. Take the worm housing into the right hand
and insert with your left hand the worm
inside the worm housing. (Picture E) The
side of the worm with the plastic end has
to face the worm housing when putting it
inside the worm housing. The worm is cor-
rectly assembled when the plastic end of
the worm stands a few millimetres out of the
worm housing. Take the adaptor disc. The
small end with the recess has to face the
worm when attaching. If necessary turn the
adaptor disc a little bit until the arresting pin
of the worm housing locks precisely into the
corresponding recesses of the adaptor disc.
IMPORTANT:
If the tools overlap the edges
of the worm housing the worm is not placed
properly inside of the worm housing. Turn the
worm a little bit to make it fit inside but do not
use force. If mounted correctly the adaptor disc
is aligned with the front of the worm housing
and the axis of the worm stands out 2 mm of
the adaptor disc.
Place the sausage attachment on the worm
housing and fit the closure ring over the sausa-
ge attachment. Firmly screw the closing ring on
the worm housing and tighten by hand.
ATTENTION:
Do not use any tools, for
tightening the screw and pay attention not to
cant the screw. If the screw cants the screw
thread gets damaged. If the screw does not turn
easily put some sunflower oil (or other edible oil)
on the screw.
2. Firmly secure the worm housing in the ope-
ning for the drive shaft. The small end of the
worm housing has to face the mincer (pic-
ture F). Incline the worm housing a little bit
to the right, when assembling it. When the
N
P
O
M
Содержание 41403
Страница 32: ...32...
