Gaspardo Monica, Руководство по эксплуатации и обслуживанию

Страница: 23 / 43

USE AND MAINTENANCE
ENGLISH
59
cod. G19502563
DISTRIBUTION ADJUSTMENT
Distribution adjustment must be done in compliance with:
- the kind of seed that has to be distributed;
- the longitudinal distance between one seed and another.
Kind of seed to be distributed :
Identify the diameter of the holes of the seed disk in Table 4 ,
according to the type of seed to distribute.
For special requirements make a specific order.
The values shown on the table are approximate. The definite
choice of seed plates is completely up to the user. Complaints
for imprecise sowing due to utilization of improper seed plates
will not be accepted.
Longitudinal distance between one seed and another :
The longitudinal seeding distance is determined by the number
of holes on the seed plate, by the number of teeth and position of
the gears on the wheel which transmits the motion to the gearbox,
and by how the gears are combined in the gearbox. The seed
spacings shown in the table are only indicative values since they
are affected by different working conditions; we therefore advise
you to check the actual spacing of the seeds in practice.
The Manufacture will not be held liable for any inconsistencies
between the values of the table and the actual values found.
On the cover of the gearbox there is a table for adjusting the
seeding distance and a table that shows the drive fitted on the
gear drive wheel.
1) From the Seed Investment Table :
Depending on both the row distance of the planter and the
selected seed investment per hectare, calculate the longitudinal
seed planting distance by using
Table 3 (Seed Investment Table).
Example:
- Seeding row distance 75 cm;
- number of seeds to be distributed per hectare: 72.000.
According to the "Seed investment Table", the longitudinal
distance between one seed and another is 18,50 cm.
For row distances differing from those listed in the table, apply
the following directions:
Example:
- Ha = 10000 m
2 ;
- Row distance = 0,90 m;
- No. of seeds to be distributed for hectare = 70.000
2) About the Seed Planter :
Verifiy which couple of pinions (Wheel) is to be found (C-D ill. no.
25) in the seed planter;
( )
Ha
Row distance
X 100
No. of seeds/ha
Longitudinal seeding distance =
( )
10000m 2
0,90
X 100 = 15,87 cm
70000
Longitudinal seeding dist =
(cm)
(*) Special for beans.
(**) The seed distributor cover should be replaced by a special one suitable for small seeds.
For special requirements make a specific order. The values shown on the table are approximate. The definite choice of seed plates is
completely up to the user. Complaints for imprecise sowing due to utilization of improper seed plates will not be accepted.
Table 4
Fig 25
C
D