Gaspardo Monica, Руководство по эксплуатации и обслуживанию

Страница: 13 / 43

USE AND MAINTENANCE
ENGLISH
49
cod. G19502563
3.0 INSTRUCTIONS FOR USE
To obtain the best performance from the equipment, carefully
follow what is set up below.
ATTENTION
All maintenance work, adjustments and preparation for
operation, must be carried out with the power take-off of the
tractor disconnected, the seeder on the ground on its
supporting feet, the tractor not running, the wheels blocked
and the key turned off.
3.1 ATTACHMENT THE TRACTOR
The seeder may be attached to any tractor fitted out with a
three-point universal joint.
DANGER
The attachment to the tractor is a very dangerous phase. Be
sure to follow the instructions carefully throughout the
operation.
3.1.1 HOOKING
The correct tractor/seeder position, is determined by placing the
equipment at a distance from the tractor so that
the Cardan joint remains extended by 5-10 cm from its maximum
closing position. At this point, proceed as follows:
1) Hook the lifter bars onto the pins provided (1, Fig. 7) Block
with the snap split pins. Hook the chains to the lifting bars
2) Connect the third upper point (2, Fig. 8); the pin will be blocked
with the appropriate split pin; use the adjusting tierod (3, Fig.
8) to keep the seeder perpendicular to the ground (Fig. 8)
3) Block the movement of the parallels of the tractor on the
horizontal plane using the stabilizers provided, so eliminating
the side swaying of the equipment. Check that the tractor
hoisting arms are positioned at the same height from the
ground.
4) Adjust the height of the tractor lifting arms:
a) In the work position, adjust the path of the tractor hoisting
arms to guarantee adequate downward movement of the
planting unit. Otherwise, when hollows are encountered in
the seedbed, seed distribution could be irregular due to
the seed planting unit transmission wheels slipping
(planing effect).
b) in the transporting position, adjust the arms so that the
seeder does not, for any reason whatsoever, come into
contact with the ground.
5) The hydraulic pipes must be connected correctly to the tractor
distributors following the instructions on each pipe (Fig. 9).
6) Connect the Cardan shaft and make sure that it is perfectly
blocked on the power take-off (Fig. 10). Check that the guard
turns freely and fix it with the chain provided.
During the work, regularly check that the equipment is
perpendicular.
ATTENTION: Always follow the indications recommended by
the Manufacturer for the transport of the seeder.
fig. 10
fig. 9
fig. 7
90 90
fig. 8
1
2
3
2
3