STEP 1.
1-1. Put the 3 post brackets on each position on the base
as shown in the picture.
1-2. Use 3 M8 x 16mm bolts to join the post brackets and
base.
STEP 2.
2-1. Put the post on the top of 3 post brackets.
2-2. Use 6 M6 x35mm bolts and nuts to connect the post to
the post brackets. Tighten the bolts and nuts.
2-3. Fill the plastic container in the base with sand.
STEP 3.
Place the cylinder housing on the stand.
STEP 4
4-1. Secure the 3 90mm pins (reflector support bolts) on
the cap of flame screen.
4-2. Route the gas hose up through the post and out of the
top.
4-3. Connect the gas hose to the gas burner inlet connector.
4-4. Connect the regulator to the hose and a gas cylinder
and leak test both of the connections using a soapy water
solution.
4-5. Attach the completed burner to the post with 4 M6 x
10mm bolts.
STEP 5
5-1. Place a washer on each reflector support bolt.
5-2. Fasten the reflector with 3 washers and 3 M8 castle
nuts.
ASSEMBLY INSTRUCTION
Tools - Adjustable spanner
Note:
Remove all transit protection material
6
