7. The hose assembly should be properly located out of
pathways where people may trip over it. The hose
must be protected from contact with hot or sharp
surfaces both during use and while in storage. The hose
assembly should be visually inspected prior to each use
of the heater. If excessive abrasion or wear is evident,
or the hose is cut, it must be replaced prior to operating
the heater. The replacement hose assembly may be
obtained from the manufacturer.
8.
DO NOT
use any pressure regulator or hose assembly
other than those supplied with the appliance.
Replacement pressure regulator and hose assembly
must be those specified. Replacement parts may
be obtained from the manufacturer or your local sales
representative.
9. Installation and use of this heater must conform with
local codes or, in the absence of local codes, with the
Standards of Storage and Handling of Liquefied
Petroleum Gases.
10. This heater is designed to operate with a standard 9Kg
propane cylinder with Approved Cylinder Connection.
11. The valve outlet must be maintained in good condition.
When the cylinder is not in use, be sure to cover it with
a dust cap. A leak test should be performed with soapy
water whenever connecting a new cylinder.
NEVER
use
a match to test for leaks.
12. The propane cylinder must be turned off whenever the
heater is not in use. When the heater is to be stored
indoors, the propane cylinder and the heater must be
disconnected and the cylinder stored in accordance
with the Standard for Storage and Handling of Liquefied
Gases. (i.e.: Not indoors, but in a dry and well
ventilated area.)
13. The patio heater has been designed with several safety
features which include a tip over switch.
NOTE:
The plastic container in the base must be filled with
sand before use.
Screw the coupling nut of regulator into the cylinder valve outlet.
(Cylinder not included)
POL CYLINDER CONNECTION DEVICE
Type of Gas
Propane
Consumption
40 MJ/h
Operating Pressure
2.75 kPa
Injector Size
1.9 mm
Any modification to the heater not described in the
installation instructions may compromise the safety of this
appliance. Special concern is as follows:
(1)
DO NOT
shorten post length;
(2)
DO NOT
bypass thermocouple safety;
(3)
DO NOT
operate heater without a reflector;
Clothing or other flammable materials should not be hung
from the heater, or placed on or near the heater. The area
above the post may be extremely hot. Direct contact with
these metal surfaces should be avoided in order to prevent
burns or clothing ignition.
Heater specifications can be found on the data label.
3
