14
15
TEST FIRING APPLIANCE
Test fire appliance, following the lighting instructions
found on the appliance. Leak test all gas connections with
soapy water. Soap bubbles indicate gas leakage.
DO NOT
use a flame to test for gas leaks.
WARNING:
White smoke may appear around
the burner during the first minute of the initial
firing.
LIGHTING INSTRUCTIONS
1.
Make sure the control knob is in the ‘OFF’ position.
2.
With cylinder valve in ‘OFF’ position turn the control
knob anti-clockwise to ‘IGNITE’ (you will hear a single
click sound). Check for sparking to the burner.
3.
If spark is not evident at the burner ignition point,
check that the ignition lead is firmly attached to the
control and sparker tip.
4.
With sparking established turn the cylinder valve ‘ON’.
5.
Push down and turn the control knob anti-clockwise
to ‘IGNITE’ again. This will light the burner. Observe if
the burner has lit. If not, repeat this process.
6.
If the burner fails to ignite after several attempts turn
off gas supply at cylinder valve and the control knob
off (clockwise). Wait five minutes before attempting to
relight with ignition sequence.
7.
Adjust the heat by turning the control knob to the
‘HIGH’/’LOW’ position.
8.
To turn off, turn the cylinder valve to the ‘OFF’
position and then turn the control knob to ‘OFF’.
Note:
If for some reason, ignitor fails to produce a spark
at the electrode, fire table can be lit by a long match.
Move lava rocks to gain access to the burner (DO NOT
touch unless completely cool). Wearing heat resistant
gloves, position long lit match close to burner port.
DO NOT lean over burner while lighting.
Push and turn burner control knob to “LOW” position. The
burner should light within 5 seconds.
STORAGE & MAINTENANCE
To obtain the best performance from your fire table, you
must perform the following storage and maintenance
activities on a regular basis:
• Allow at least 30 minutes for the fire table to cool down
after use, then disconnect and remove the cylinder.
• Store the gas cylinder in a dry, well ventilated and
sheltered area away from weather and dust, out of
the reach of children, and not in a building, garage or
any other enclosed area.
• Storage indoors is permissible only if the cylinder is
disconnected and removed. It is recommended that
the fire table be stored indoors during the winter if it
will be subjected to freezing temperatures.
• Keep the fire table area clear and free from
combustible materials, gasoline and other flammable
vapors and liquids.
• If the fire table is not in use, it must be covered to
protect from weather or other adverse elements.
• Never use a vacuum cleaner on the lava rocks.
• Installation and repair should be done by a qualified
service person.
• The fire table should be inspected at least annually by
a qualified service person. It is imperative that
control compartment, burners and circulating air
passageways of the fire tablet be kept clean.