3
2
WARNING: Fire risk exists if this heater is covered or
positioned close to combustible materials.
Always ensure you select the correct fixing
accessories which suit the particular material you
are attaching to, if in doubt please discuss with your
local retailer or local hardware store. This heater is
not designed for use within 1m or above a water
source. All installations must meet the requirements
of Australia Standard AS/NZS 3000:2007.
NOTE: When using this heater outside ensure that it
is connected directly to an outdoor power point.
The electrical system of this heater must be
connected with an automatic 30mA circuit breaker
and/or residual current device (RCD). If uncertain
have a qualified electrician check your electrical
system before installation and/or use.
All electrical connections are made in a dry area.
Outdoor power points must be weatherproof and
installed by a qualified electrician.
The distributor is not responsible for incorrectly
chosen additional fixing accessories or any damage
which may be caused by an incorrectly fitted heater.
FOR YOUR SAFETY
• Do not twist, kink or wrap the cord around the
heater as this may cause the insulation to weaken
and split.
• This heater is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
heater by a person responsible for their safety.
• Children should be supervised to ensure that they
do not play with the heater.
• This heater is intended for light domestic use and
not for heavy duty commercial or industrial use.
• The heater must not be located immediately
below or in front of a socket-outlet.
• CAUTION: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out, this
heater must not be supplied through an external
switching device, such as a timer, or connected
to a circuit that is regularly switched on and off by
the utility.
• Never remove the cover of the heater – in case of
a fault contact a qualified service person.
• Repairs should only be carried out by qualified
persons using original spare parts. Failure to
do so may result in considerable danger to the
operator.
• Use this heater only as described in this manual.
• Any other use is not recommended by the
manufacturer and may cause fire, electric shock
or injury.
• The remote control function is line of sight and
may not operate if something or someone is in the
way of the signal.
Installation
This heater is not designed for use within 1m or above a
water source.
Ensure that the heater is not positioned directly above,
below or in front of a power point or switch.
This heater is not designed to be used with 3rd party
timer or programmable system.
This electric heater complies with New Zealand and
International standards and safety requirements. All
installations must meet the requirements of New Zealand
Standard AS/NZS 3000:2007.
ELECTRICAL DATA
IMPORTANT
This product is fitted with a sealed electrical connection
plug that is compatible with the heater, the mains
supply for New Zealand and meets the requirements of
international standards. This heater must be connected
to a supply voltage that is equal to that stated on the
rating label.
If the mains connection plug or power cord becomes
damaged it must be replaced with a complete assembly
that is identical to the original, and this must be replaced
by an authorised service centre.
Always follow the New Zealand requirements for
connection to the mains supply. If in doubt always
consult a qualified electrician.
Technical Specification
Model
GM135-045
Voltage:
220V-240V~ 50Hz
Input Wattage:
2400W
Unit Weight:
4.1kg
IP Rating:
IP65
Heater specifications can be found on the data label.
Содержание GM135-045
Страница 7: ...7...
