7
6
2
3
15
FIG. C
FIG. B
Fig. A Assembled
ASSEMBLY
BASE ASSEMBLY FIG. A
1. Turn the Base upside down and attach both
Wheels (5) and then screw in both Feet (1)
and adjust them to the same level as the
Wheels.
2. Turn the base the correct way up and place
the Base Cover (9) on. Make sure the 3 holes
in the Base Cover match the Base.
4. With the Base and Base Cover on its side
push M8*120 through the Base, Base Cover.
Now slide the Tube (10) over the screw. Now
attach the Foot Ring (12) with this screw.
5. Repeat step 4 for the other 2 Tubes (10).
HEATER ASSEMBLY FIG. B & FIG. C
6. Lay the Heater Body on its side next to
the assembled base. Feed the power cord
through the large hole in the assembled base.
7. Slide the heater body up to the assembled
base and attached with the Base Bracket (3)
and screw (2). Make sure the Base Brackets
(3) match up with the holes on the Base
Cover and assembled Base.
8. Pull the Power Cord out fully through the
assembled base and clip into the Cord Clip
(15).
1
6
10
12
5
9
FIG. A
