8
- Controller showing high altitude mode activated
- Controller showing remote control pairing mode
- Selecting remote control 1 (OC1)
HIGH ALTITUDE MODE
When the heater is to be used in areas of high altitude
for prolonged periods of time (at over 1500m above sea
level), the high altitude mode (
) should be activated
to ensure reliable operation. The heater will adjust
the amount of fuel supplied to the combustion chamber
to balance the thinner air at high altitudes and ensure
the optimal air/fuel mixture is used.
To activate the mode:
1. While the heater is in standby, press and hold
the SETTINGS (
) and OK (
OK
) buttons together
for 2 seconds.
2. Once activated, you can operate the heater
in the normal way.
3. To deactivate, press and hold the same 2 buttons
for 2 seconds.
REMOTE CONTROL
The supplied remote control allows basic operations
within a short distance from the heater, such as inside
an RV or tent with the heater unit outside.
Before attempting to pair the remote control, ensure
it has a battery fitted and in good condition.
The remote control uses 12V alkaline battery of type A27
(also known as MN27, L828 & 27A). The battery can be
accessed by removing the 3 rear case screws and lifting
off the front of the remote case.
Before first use and each time the power is disconnected
and reconnected, the remote control must be paired with
the main controller by following the steps below
1. While the heater is in standby, press and hold the
POWER (
) and DOWN ( ) buttons together
for 2 seconds.
2. Use the UP ( ) or DOWN ( ) buttons to select
the remote control being paired (up to 5 remote
controls can be paired to the one controller). If there
is only 1 remote control, select OC1 on the controller
as shown below.
REMOTE CONTROL
The remote control buttons and functions
are detailed below.
ON
Turn on
Turns the heater unit ON
OFF
Turn off
Turns the heater unit OFF
+
Increase value
Increases the selected
value (heating level
or set temperature)
-
Decrease value
Decreases the selected
value (heating level
or set temperature)
3. Press any button on the remote control to send
a signal to the controller to pair with it.
4. Press the SELECT (
OK
) button to confirm and exit
the pairing mode. The remote should now be paired.
5. To exit the pairing mode without saving the settings,
press the SETUP (
) button.
