Gasboy ORPAK CFN PLUS, Руководство по установке

Страница: 19 / 90

MDE-4813D CFN PLUS Installation Manual · February 2018
9
1-5.3. Dispensers
CFN PLUS can support either mechanical or electronic Dispensers, in accordance with its
configuration. Mechanical Dispensers require the installation of MPI-C cards on the 8-port
Convertor. Electronic Dispensers (Tokheim
®
, Current Loop or RS-485) require installation
of interface relevant cards on the 8-port Convertor.
In the order form, you are required to define also the P/N for the specific pump card in use (MPI-C,
Tokheim, Current Loop or RS-485 - see
Table 1-1 ).
Table 1-1. Dispensers Card Definition
No. Pump Card Description Gilbarco P/N Orpak P/N
1 Tokheim interface (8P) P.B. M09680B028 819223420
2 Current Loop interface (8P) P.B. M09680B029 819223431
3 RS-232 Interface (8P) P.B. M09680B016 819223451
4 RS-485 Interface (8P) P.B. M09680B017 819223460
5 MPI-C + Sub Interface (8P) P.B. M09680B019 819223490
1-5.4. OrTR (Orpak Tag Reader)
OrTR (P/N PA04020001) - OrTR (Orpak Tag Reader) receives tag signals for refuel authorization
purpose. OrTR transmits the information to the Station automation system (OrCU) over a CAT-5E
or RS-485 cable. OrTR is designed to be installed in a nonhazardous location in the station. Two
installation alternatives are available:
•
External box on the station wall or pedestal. This installation mode requires a dedicated
mounting bracket. Such an installation shall be performed within safety distances required
for any installation adjacent to dispensers. See
Figure 3-1 for instructions.
•
Installed beneath CFN PLUS box with mounting bracket.
More than one OrTR can be mounted in one station for improved service. In this case all OrTR
shall be connected to the same, single OrCU via RS-485 or Ethernet.
For further details, refer to MDE-4816 OrTR Installation Guide .