GAS GAS F0001U1, Руководство пользователя

Страница: 39 / 104

SUSPENSION SETTING 11
37
11.15 Handlebar position
M01659-10
On the upper triple clamp, there are 2 holes at a distance of
A
to each
other.
Hole distance
A
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of
B
from
the center.
Hole distance
B
3.5 mm (0.138 in)
The handlebar holder can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable position
for the rider.
11.16 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
M01659-11
–
Remove screws
1
. Take off the handlebar clamps. Remove the
handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
2
. Take off handlebar supports.
–
Place handlebar supports in required position. Mount and tighten
screws
2
.
Guideline
Screw, handlebar
support M10 40 Nm (29.5 lbf ft)
Loctite ® 243™
Mount the left and right handlebar supports in the same position.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
1
and tighten
evenly.
Guideline
Screw, handlebar
clamp M8 20 Nm (14.8 lbf ft)
Info
Make sure the installed gaps are even.