GAS GAS EC FSE 400, Руководство по ремонту

Страница: 83 / 104

Inspection and maintenance
81
Place the interior pail over the bench with the
arrow directed in the direction contrary to the
operator.
Remove the aperture springs of the APTC pails
that stayed in the exterior pail and introduce them
in the interior pail.
Remove the conductors and conducting disks
from the interior pail of the clutch unit. Carefully
clean all the clutch unit components. It is preferable
to use detergents similar to percloretylene (PCC).
After the cleaning, dry all the components using
compressed air.
Check the wear of all the components and replace
the damaged or worn out components using
original GAS GAS.
Notes:
Do not use pointed tools or aggressive
detergents to clean the components of the
clutch unit, since some of the surfaces of the
same components are covered with an anti-
wear covering with low friction coefficients.
The conducting and conducting disk package
should be replaced when the total package
thickness of the 8 covered conducting disks
is lower than 21 mm.
The thickness of the 8 covered conducting
disks lower than 21 mm does not guarantee
the correct functioning of the clutch unit.
The use of non-original GAS GAS components
does not guarantee the correct functioning of
the clutch unit.
Before assemblingthe clutch unit it is necessary
to lubricate allthe components using oil for engines
conforming to the GAS GAS prescriptions.
Support the exterior pail over a flat surface, as
shown in the image, and introduce alternately the
8 covered conducting disks and the 7 conducted
disks starting with a covered conducting disk.
Support in the work bench the interior pail with
opening springs in the upper part.
!