4. As shown, wrap searchcoil cable securely
around stem and connect to detector. The first
cable turn goes over the top of the stem. The
cable should be snug but still slightly loose so
that the angle of the searchcoil can be
changed easily, when required. To connect
cable to the detector insert the cable connec-
tor, as shown below, into the housing connec-
tor and rotate collar clockwise until secure
(approximately four turns). Hand tighten only.
Never use any kind of lubricant.
The Investigator G-500 is equipped with eight
(8) AA batteries.
housing. The two sets of buttons will enable
you to secure the top stem to the control hous-
ing and adjust length of the overall stem.
2. Attach the lower stem to the searchcoil by
inserting the two rubber washers onto this
stem and slipping the searchcoil onto it. Place
the threaded bolt through the holes in the con-
nector and hand-tighten the knobs. Use no
tools. Insert upper stem into the control hous-
ing.
3. Depress the buttons in the lower stem and
insert it into the upper stem. Let buttons pop
into the holes to achieve desired stem length.
The third set of holes from the end is most
commonly used.
11
PN 1529570 Rev B
10
Garrett G-500
