Garnet SEELEVEL II 714, Руководство пользователя

Страница: 7 / 25

Page 7
714 / 714-P Manual
3. Press the top “TOP” button to toggle between primary and
secondary scanning mode. The bottom button will store and
exit the menu, all the displays will show “Sto” until the button
is released. Normal operation will then start.
4. The LPG must be wired to the primary display only.
5. If the primary display malfunctions the secondary display will
automatically take over the functions of the primary.
To calibrate the number of senders for each tank:
1. This should only be done at the time of installation, there is
no reason to change this afterward. Hold down the button
beside the applicable tank label (FRESH, GREY, or BLACK). The
display will show “HLd, then “dIA”, then “AnA, and then “FrS/
GrS/bLS” for Fresh/Grey/Black number of senders. This will
take about 15 seconds. When this occurs release the button.
2. The display will now show “1SE/2SE” (one/two senders) These
are the only two options, the display will not work with more
than two senders per tank. The bottom display will show
“dun”.
3. To change the number of senders, press the tank button, each
time the button is pressed the display will store the value.
4. When the display shows the correct number of senders,
press the bottom button, this exits the menu and resumes
scanning with that tank. Each tank will need to be calibrated
individually using this procedure.
To program the LED brightness:
1. If the display is to be used inside the coach, the LED brightness
should be low. If it is to be used in the service bay area where
sunlight can reach it, the LED brightness should be high.
2. Press and hold the bottom button and then the second button,
release buttons when display shows “Set bri UP dn dun”.
3. The third button (UP) increases the brightness and the fourth
button (dn) decreases the brightness.
4. The current brightness level (“b-1”, “b-2”, “b-3”, or “b-4”)
will be shown while the UP or dn buttons are held, where
“b-1” is the minimum brightness and “b-4” is the maximum
brightness.
5. When the display shows the correct brightness, press the
bottom button to save the brightness level. When the bottom
button is pressed all the displays show “Sto” to indicate the
brightness level has been stored.