Garnet SeeLeveL II 709-RVC, Руководство пользователя

Страница: 22 / 35

Page 22 709-RVC Manual
7. To make the senders the right length (assuming they are too
long) they will need to cut off with a pair of scissors. The end
to be cut is the bottom end, which is the opposite end from
the top where the wires come out (see the diagrams).
8. The senders need to be programmed so they know which tank
they are on. This is done by selectively cutting off the tabs
on the top of the sender. See the chapter entitled “SENDER
PROGRAMMING” for details.
9. For double stacked sender systems, the senders also need to
be programmed so they know whether they are being used
as top or bottom senders. See the chapter entitled “SENDER
PROGRAMMING” for details.
10. Once the sender is cut to length and programmed, do a test
by taping the sender to the tank wall. Make sure there are no
air gaps between the sender and the tank. Verify operation
before permanently sticking the sender to the tank wall.
Once proper operation has been confirmed, carefully peel the
backing paper off the adhesive. Do this slowly to prevent the
adhesive from being ripped off the sender, and to prevent
the backing paper from ripping. Be careful not to bend the
sender sharply in the process. Position the sender over the
side of the tank and carefully stick it down.
Position the bottom of the sender at least 1/4 ” above the
bottom of the tank, or slightly higher if required to equalize
the space at the top and bottom of the tank. Make sure that
the sender is square with the tank. You only have one shot
at this, if you try to peel it off the tank once it is stuck the
sender may be damaged by the sharp bending. Carefully
press the sender down to the tank so that all of the adhesive
is contacting the tank wall.
11. Do steps 5 to 10 for the other two holding tanks.
12. Connect all the blue wires from the senders together, and to
the blue wire from the display. Connect the black wire from
each sender to ground at the display. It is very important that
the display and the senders have the same ground. Use crimp
on butt connectors to fasten the wires together.
W
CAUTION: DO NOT cut the sides, and DO NOT cut the 710ES
sender shorter than 4
1/2
”. The cut must be in between the sensor
pads, and the cut must be made parallel to the existing bottom
end. Double check your measurements, if the sender is cut too
short, it cannot be lengthened.
W
CAUTION: Make sure that the end with wires is pointing up!!