TS-1 Operation and Installation Manual
Page 2
WARNINGS
WARNING HIGH VOLTAGE! NEVER
Power up this equipment with covers or safety features
removed. Even when the equipment is powered down, high voltage (up to 1,000 Volts) can be
present inside the chassis.
WARNING! NEVER
remove the ground pin from the power cord nor use a plug adaptor that
doesn’t provide grounding continuity.
WARNING! NEVER
disable safety interlocks. Doing so can allow unpredictable operation that is
dangerous to the equipment operator and bystanders.
CAUTION! NEVER
change the internal settings of this equipment. This may reduce the
equipment performance and/or cause damage to the equipment. In particular, incorrect settings
for power mains. The equipment warranty does not cover any problems caused by
unauthorized internal adjustment.
CAUTION!
The equipment weighs approx. 66 kg (146 lb). Always have two people available to
carry, lift or turn over the equipment.
CAUTION!
Be sure the table, desk, or bench this equipment will be operated or stored on is
stable and can support the weight of this equipment. If this equipment falls on someone, it can
cause serious injuries or death.
CAUTION!
The line-voltage receptacle must be near the equipment and must be easily
accessible. Avoid extension cords.
NEVER
let metal, wire or other objects protrude into the equipment. This may result in an
electric shock, electrocution or damage to the equipment.
NEVER
block any cooling vents on the top, rear or bottom of the equipment.
NEVER
expose the equipment to rain, snow or any liquids.
NEVER
operate the equipment dusty or dirty environments. Doing so can cause damage to the
equipment and void the warranty.
NEVER
install the equipment in a place without adequate ventilation. Heat dissipation may be
reduced, and the equipment may be damaged.
NEVER
operate or touch the equipment with wet hands. This may result in an electric shock or
damage to the equipment.
AVOID
using or storing the equipment in areas with temperatures below 0°C (+32°F) or above
+50°C (+122°F).
AVOID
placing the equipment in excessively dusty environments or in direct sunlight.
AVOID
placing the equipment against walls or putting anything on top of the equipment. Always
place unit in a secure place to avoid inadvertent use by unauthorized personnel.
