EN–3
The spoke magnet can
face away from the
GSC 10 if there is not
enough room between
the sensor arm and the
spoke. The spoke magnet
must line up with the
indication line
➑
on the
sensor arm.
6. Loosen the screw
➒
on
the sensor arm.
7. Move the sensor arm to
within 5 mm of the spoke
magnet.
You can also tilt the
GSC 10 closer to either
magnet for improved
alignment.
8. Press the
Reset
key
➓
on
the GSC 10.
The LED turns red, then
green.
9. Pedal to test the sensor
alignment.
The red LED blinks each
time the pedal magnet
passes the sensor. The
green LED blinks each
time the spoke magnet
passes the sensor arm.
NOTE:
The LED blinks
for the first 60 passes
after a reset. Press
Reset
again if you require
additional passes.
10. When everything is
aligned and working
correctly, tighten the
cable ties, the sensor arm,
and the spoke magnet.
Garmin recommends that
the torque is 1.9 to 2.4
lbf-in to ensure a water
tight seal on the GSC 10
sensor arm.
When the GSC 10 is paired,
a message appears, and
appear solid on the
status page.
Pair the Sensors
Pairing is the connecting of
ANT+
™
wireless sensors,
for instance your GSC 10
with an Edge. After you pair
the first time, your Edge
automatically recognizes
your GSC 10 each time it is
activated.
NOTE
: The pairing settings
differ for each compatible
Forerunner and Edge model.
See your owner’s manual.
GSC 10 Battery
WARNING
Do not use a sharp object
to remove user-replaceable
batteries.
190-00646-00_0H.indd 3
7/2/2012 7:51:31 AM
