59
GPSmap 76CS
GPS Navigation
IMPORTANT NOTE:
When the USB cable is con-
nected to the GPS map 76CS,
it is automatically detected and
communicates only in Garmin
Format. When the USB is con-
nected, Garmin format will not
communicate through the Serial
connection, while all other
formats can be used by the
Serial connection with the USB
still connected.
RTCM In
- Provides DGPS input using a standard RTCM SC-104
format.
No
output.
RTCM In/NMEA Out
- Allows DGPS input using a standard RTCM
SC-104 format and supports the output of standard NMEA
0183 version 3.01 data.
RTCM In/Text Out
- Allows DGPS input using a standard RTCM
SC-104 format and supports the output of simple ASCII text output of
location and velocity information
None
- Provides no interfacing capabilities.
To change an Interface Setup feature:
1. Access the Interface Setup Page as explained at the beginning
of this section.
2. Highlight the desired setting and press
ENTER
.
3. When you select Text Out and /or RTCM In, additional fi elds will
appear. Use the
ROCKER
key to highlight “Baud Rate” and
press
ENTER
. Use the
ROCKER
key to highlight the desired
setting and press
ENTER
.
4. For Garmin DGPS or RTCM In/NMEA Out, use the
ROCKER
key
to highlight “Beacon” and press
ENTER
. Use the
ROCKER
key
to select “Scan” or “User” and press
ENTER
.
If “Scan” is selected, the GPSmap 76CS will automatically direct
the beacon receiver to scan for available beacon transmitters.
If “User” is selected, select the “Freq” and “Bit Rate” fi elds and
enter the appropriate settings. The beacon status, signal-to-noise
ratio and distance to beacon are displayed in the bottom of the page.
Interface Setup
Data Format Page for
GARMIN DGPS
Data Format Page for:
NMEA In/NMEA Out
Text Out
RTCM In
RTCM In/Text Out
Data Format Page for
RTCM In/NMEA Out
GPSmap 76CS Owner's Guide copy.indd 59
GPSmap 76CS Owner's Guide copy.indd 59
10/8/2004 8:28:17 AM
10/8/2004 8:28:17 AM
