GPSMAP 5000 Series Owner’s Manual
Using Radar
U
Sin
G
r
adar
Using Cruising Mode
Cruising mode is the standard radar operation. If you switch from Sentry mode (see Using Sentry
Mode) to Cruising mode, the antenna will go into full-time transmission and will disable any guard
zones.
To enable Cruising mode, touch
Radar
>
Cruising
.
Use the Cruising screen to view a full-screen image of the gathered radar information. Your position
is in the center of the screen, and the rings provide distance measurements.
Range rings
Heading line
Zoom scale
Distance
between rings
The zoom scale represents the distance from your position (the center) to the outermost ring. Each
ring represents an even division of the zoom scale. For example, if the zoom scale is set at three
miles, each ring represents one mile from the center out. Adjust the zoom scale using the and
buttons.
Using Sentry Mode
Note:
When Sentry mode is enabled, all MARPA targets are cancelled, and you cannot acquire
MARPA targets until you exit Sentry mode.
Sentry mode allows you to put the radar antenna into timed-transmit mode, in which you can
configure a transmit and standby cycle. You can also enable a guard zone in Sentry mode, which
identifies a safe zone around your boat. An alarm sounds when a radar object enters this zone.
To enable Sentry mode, touch
Radar
>
Sentry
.
To enable timed-transmit mode:
From the Home screen, touch
Radar
>
Sentry
>
Menu
>
Sentry Setup
>
Timed Xmit
.
To set the standby and transmit times:
1. From the Radar screen, touch
Menu
>
Sentry Setup
.
2. Touch
Timed Xmit
if it is set to off, and then select
Stdby Time
or
Xmit Time
.
3. Enter the time in minutes using the on-screen keyboard and then touch
Done
.
