9
190-00607-02 Rev C
Detailed Operation
These areas are called “hot spots” and are identified
by circular or elliptical lines. Although these areas are
highlighted as places where extra caution is war-
ranted and advised, they do not relieve the pilot of
the responsibility to “see and avoid” other traffic or
obstacles, on the airport surface or in the air. All taxi-
way and runway intersections should be approached
with caution, whether they are marked with hot spots
or not. Runways where Land and Hold Short Opera-
tions (LAHSO) may be in effect are identified with
lines across the runway labeled “LAHSO”. Other areas
where extra vigilance is recommended may also out-
lined. Hot spots and other outlined areas are derived
from database information and may therefore contain
errors or may not be included in the database.
typical operational Scenario
The following scenarios makes the assumption that:
•
The appropriate charts are available and geo-refer-
enced
•
The default ground zoom level is set to 0.5 NM
•
The default air zoom level is set to “AUTO”
•
Airport Chart menu item is enabled
Typical Taxi Scenario
On power up and GPS position acquisition, the
Custom Map Function will show the aircraft on the
surface chart at a zoom level of 0.5 NM. The air-
craft will be shown relative to taxiways and runways
throughout the taxi procedure.
Typical Take Off Scenario
On take off roll, when the aircraft reaches the air/
ground transition speed, the display will automatically
transition to the en route zoom mode of “AUTO” and
adjust the display to show the active waypoint.
Typical Approach Scenario
Setting the last waypoint in the flight plan to the
destination airport on the GPS navigation system and
pressing
LOAD CHART
from the Custom/IFR Map
will present the destination airport in the selection list.
Selecting this airport will then bring up the approach
charts that are available for that airport, which can
then be loaded by pressing the
Load
key.
Typical Landing Scenario
With an approach chart being “flown,” upon
touchdown and rollout, the chart will be unloaded
and the map will automatically switch to the airport
surface chart with the zoom level set to 0.5 NM.
ChartView - Chart
Содержание GMX 200
Страница 1: ...GMX 200TM Pilot s Guide Reference ...
Страница 26: ...14 190 00607 02 Rev C Getting Started Function Summary ...
Страница 146: ...134 190 00607 02 Rev C Index This page intentionally left blank ...
Страница 147: ......