GFL 10 Installation and Configuration Instructions
Troubleshooting the Gauge Type
When connected to a gauge, the GFL 10 adapter gauge type is set to
auto Detect
by default,
and the adapter automatically detects the type of gauge it is connected to. If the fluid-level
reading on a connected Garmin chartplotter or marine instrument changes with the engine
RPM, the adapter may be detecting the wrong type of gauge.
note:
The fuel level changes when the boat is moving. Test the gauge-type setting when the
boat is not moving.
To test the gauge-type setting:
1. When the boat is not moving, put the engine in neutral.
2. Use the throttle to increase the engine RPM. If the fluid-level reading changes with the
engine RPM, change the gauge type.
To change the gauge type:
1. From the NMEA 2000 Devices list, select the GFL 10 device.
2. Select an option:
For most Garmin chartplotters, select
Review
>
Gauge Type
.
For other Garmin marine devices, select
Config
>
Gauge Type
.
3. Select an option:
To automatically detect the gauge type, select
Auto Detect
.
To indicate a one-coil gauge, select
1 Coil
.
To indicate a two-coil gauge, select
2 Coil
.
4. Perform the gauge-type setting test.
Resetting the Fluid Level Calibration
You can reset the fluid-level calibration of the tank that the GFL 10 adapter is associated with.
1. From the NMEA 2000 Devices list, select the GFL 10 device.
2. Select an option:
For most Garmin chartplotters, select
Review
>
Level Calibration
.
For other Garmin marine devices, select
Config
>
Level Calibration
.
3. Select
Reset Calibration
.
4. Select
Yes
.
5. Calibrate the fluid level.
•
•
•
•
•
•
•