Garmin Diamond DA40, Руководство по обслуживанию

Страница: 44 / 156

Page 3-6 G1000/DA40 System Maintenance Manual
Revision 6 190-00303-03
3.4.2 Configuration Files
A G1000/DA 40 SW Loader Card typically contains the following configuration files:
•
AIRFRAME: This file contains data such as airspeed parameters, engine/airframe sensor
limitations, fuel tank parameters and alerting system settings that tailor a G1000 PFD or MFD
to the DA 40.
•
SYSTEM: This file configures the G1000 Ethernet to expect a PFD, MFD, and two GIAs.
•
MANIFEST: This file loads a manifest of all software part numbers and versions associated
with an approved system configuration.
•
MFD1: This file configures MFD serial/discrete communication and alert system settings.
•
PFD1: This file configures PFD serial/discrete communication and alert system settings.
•
GIA1/GIA2: These files configure GIA1/GIA2 serial/discrete communication settings.
•
GMA1: This file configues GMA 1347 audio and serial communication settings.
•
GTX1: This file configures GTX 33 transponder and serial communications settings.
•
GEA1: This file configures GEA 71 engine/airframe parameters.
•
GDC1: This file configures GDC 74A air data values for the DA 40.
The above files are loaded during the configuration processes listed in Section 7 and Appendix B. Each
file is sent directly to the applicable LRU. The same file is also stored in PFD internal configuration
memory. The PFD also sends a copy of all configuration files to it’s connector configuration module. If
the PFD is replaced, the configuration module retains all configuration files in the aircraft.
The GRS 77 AHRS and GMU 44 Magnetometer do not utilize a configuration file.
However, these LRUs do require several calibrations during installation checkout to tailor
sensor characteristics to a specific DA 40 airframe. While performing maintenance on
these units, re-calibration may be required. See Section 7.7.3 for more information on
re-calibration criteria.
NOTE