Garmin BC 30, Быстрый старт

Страница: 8 / 62

8 BC30
TM
directly on the surface of your vehicle,
mark the locations of the two holes on
the bracket.
• If you are installing the camera on
a license plate, remove one of the
license plate screws so the hole on
the camera lines up with the hole on
the license plate.
3 Secure the bracket to the vehicle using
either the included self-tapping screws
4
or the license-plate screw you
removed in step 2
5
.
4 Place the camera in the bracket, and
determine the best place for the camera
cable
6
to enter the vehicle.
5 Using an appropriate drill bit, drill a
hole for the camera cable to enter the
vehicle.
6 Feed the camera cable through the hole
and route it to the transmitter location.
15 m (50 ft.) extension cables can be
purchased separately, if needed.
7 Secure the camera in the bracket using
the included hex bolts
7
.
8 Adjust the angle of the camera and
tighten the hex bolts using the included
hex key.
9 Apply RV sealant around the cable
where it enters the vehicle (optional).
Installing the Transmitter
Before you permanently install the transmit-
ter, you must test the installation
location for correct operation (page 4).
1 Secure the transmitter to the installation
location using hardware appropriate
for the location, such as screws, bolts,
or cable ties. The fuse holder located
near the transmitter is not waterproof.
Installing the fuse holder in a location
that is exposed to the elements is not
recommended.
2 Connect the camera and transmitter
cables. The connector between the
camera and the transmitter is not
waterproof. If you make this connection
in a location exposed to the elements,
you must make sure that the connection
is waterproof.
3 Connect the power cable
1
from the
transmitter to a 12–24 VDC power
source, preferably a reverse lamp
1
using a solder less wire-splice connec-
tor (not included).