18
WARNING
This product is not suitable for use by children under 3 years. Small balls and parts
might be swallowed or inhaled.
Carefully read the Guide for a safe use on page 23-24
UNPACKING AND ASSEMBLY
Important:
keep away the children during the assembly. For safety reasons it is
strongly recommended the football-table assembly by at least two adults.
Lay the carton box on the floor. Note: the box label shows clearly the upper part.
Cut the adhesive tapes and remove completely the carton top. Lower the sides
of the box bottom: the football-table is packed upside down. Remove the
wooden panels for things clamping inside the cabinet: they belong to the
packing and they are of no use.
List of tools:
a cross screwdriver and a hammer (not supplied).
Take off the packing contents and check that all parts listed below are included.
WARNING:
the small parts (such as bearing retainers, roller bearings, screws and bolts) when not assembled, may
be swallowed or inhaled: keep them away from children.
4 Pcs.
Bolt with thread
2A5-102
8 Pcs.
Set of telescopic bars with
inner bars and bearing
retainer 2AN201-314 for
innerbars – installed
2A4-16RAVBIPT
8 Pcs
Roller Bearing
handle side
2AN201-1
16 Pcs.
Outer half bearing
retainers without pin
handle side
2AN201-21
16 Pcs.
Inner half bearing
retainers with pin
handle side
2AN201-24
8 Pcs.
Handles
2A203-5
8 Pcs.
Bearing retainers with two
pins for inner bar (already
installed on the inner bar)
2AN201-314
8 Pcs.
Outer blind bearing retailer
to close the telescopic
side2AN201-311
32 Pcs.
Screws
2A5-3.5X25E
