Garland XTRIM 575 E, Инструкция по эксплуатации

Страница: 33 / 124

English
32/124
English
33/124
1. Loosen the ring by turning it in the direction
marked by the unlock arrow.
2. Lengthen or shorten the pole to desired length
3. Tighten the ring by turning it in the direction
marked by the arrow.
Be sure that you pressed the ring tight enough before
starting up the machine.
6.3.4. SPINNING 180º
Pull the ring (1) and rotate
the motor 180 ° (2).
6.3.5. CONTROL OF THE WORKING ANGLE
Press the button and adjust
to the desired angle.
6.3.6. TURNING ON AND OFF
To turn the machine ON:
Press the Om/Off switch
(A).
To turn the machine OFF:
Release the On/Off switch
(A).
After the machine is switched off the blade will
continue to turn because of inertia.
Wait until the blade stops before carrying or
performing maintenance work on it.
6.3.7. CHECKPOINTS AFTER TURNING THE MACHINE
ON
It is important to pay attention to the possible loose
parts and/or the temperature of the machine. If you
detect anything unusual in the machine, immediately
stop and check it carefully. In case of any malfunction
or problem take the machine to be repaired.
Never continue to use the machine if the operation
does not seem appropriate. Do not use the machine if
it is damaged or incorrectly adjusted.
A
180º 2
1
1
2