Installation
RTCSmp Induction Built-In Line Dual Zone Cookers
12
Part # 4532285 Rev 4 (4/29/14)
4.3.2
Control Unit Installation
The induction unit comes with two complete control units — one for the front cooking zone and one for the rear
zone. Each control comes with a 36” (914mm) RJ-45 cable.
NOTE
Install the control units
VERTICALLY
on the cabinet panel. There are two methods to install a control
unit: front-mount or back-mount onto the panel.
Installers are responsible for choosing the appropriate fasteners for the installation.
4.3.2.1
Front-Mount
To mount the control unit
onto the front of the panel:
1.
Drill holes and make the
cut-out using the
dimensions and the
actual unit provided.
2.
Secure the control unit to
the panel with fasteners.
Illustration: Measurements in
mm and [inch].
4.3.2.2
Back-Mount
NOTE
For this type of installation, the maximum thickness of the panel must not exceed 1.5mm or 16 gauge.
This restriction ensures a proper grip on the knob and the LED light will not be obstructed.
To mount the control unit
onto the back of the panel:
1.
Drill holes on the panel using
the dimensions provided.
2.
Remove the plastic knob
from the control unit and
attach the control unit to the
panel with fasteners as
shown.
NOTE: DO NOT
remove or loosen any
screws on the control unit
.
Illustration: Measurements in mm
and [inch].
Front Panel
Front Panel
12 [ .474]
10.11 [ .398]
11.91 [ .469]
maximum
1.5 [0.06]
