Garland moisture+ MPGD10D, Руководство по обслуживанию

Страница: 27 / 80

Part # MPSM07 (03/24/08) Page 27
When the oven is in Cool Down or Auto Cool Down modes the
display will show this message . It indicates the oven is cooling and
shows the actual temperature of the cavity .
While in Cool Down, if the door is open too far, as sensed by door
switch two, this message is displayed to prompt the user to close the
door to the desired open range so the fan and motor will turn back
on to finish the cool down .
While in Cool Down, if the door is not open, as sensed by door switch
one, this message is displayed to prompt the user to open the door .
When programming the control for cooking cycles using the core
probe, this display will be shown prompting the user to program the
internal temperature to be sensed by the core probe .
When cooking with the Core Probe this message will appear
alternately with the oven temperature display . The programmed
probe temperature and actual probe temperature will be displayed
on the left side . The word “PROBE” in the upper right hand corner
replaces the clock to indicate the cook cycle is being controlled by
the probe . The word “HEAT” in the lower right hand corner will cycle
on and off with the burners/elements . This display will alternate at
two second intervals .
When cooking with the Core Probe this message will appear
alternately with the probe temperature display . The oven cavity
programmed temperature and actual oven temperature will be
displayed on the left side . The word “CAVITY” in the upper right
hand corner replaces the clock to indicate the cook cycle is being
controlled by the probe . The word “HEAT” in the lower right hand
corner will cycle on and off with the burners/elements . This display
will alternate at two second intervals .
Press and hold the Program Key for three seconds to enter the
programming mode for Product and Shelf Timer keys . This display
will prompt for the four digit password code so programming can
continue .
After entering Program Mode, the key to be programmed must be
identified .
Once the key has been selected, you first must indicate whether it will
be programmed as a product key or as a shelf timer .