Garland CS BEST 100, Инструкция по эксплуатации

Страница: 31 / 104

English
30/108
English
31/108
as in the figure and check that oil comes off the tip of
the bar.
Ensure the oil reservoir is topped up every time fuel
is added.
6. USING THE MACHINE
Only use this machine for those jobs it has been
designed to do. The use of this machine for any other
use is dangerous and could cause damages to you
and/or the machine.
Be extremely careful when using the machine after it
has been raining as the floor could be slippery and you
could slip.
If you lose your stability or if you fall, let go of the
accelerator trigger straight away.
Do not approach the machine when the motor is
running.
Do not solely rely on the security features of this
machine.
It is necessary to pay attention to the possible loosening
or overheating of the parts of the machine.
If you detect any anomaly immediately stop the
machine and check it carefully. In case of mechanical
failure take the machine to the technical service for
repair.
You should not continue working if you notice that the
operation is not correct.
Remember to always use the machine with clean
hands and without any fuel or oil remains.
Clean the work area and remove all obstacles that may
cause accidents. Check the work area when going to
work and remove all items that could become entangled
in the cutting tool. Also remove all the objects that the
cutting tool can violently eject in the operation.
Never use the machine when on top of a ladder, in a
tree or in any other unstable surface. Do not use the
prunner one handed.
You must turn off the engine when you are moving
between work areas.
Verify the state of the tree prior to cutting to ensure
that dry branches will not fall off on top of you whilst
cutting.
Whilst cutting, ensure that the tip of the bar does not
come into contact with any trunks or other obstacles.
Maintain the chain always well sharpened. Sharpen as
described in this manual.
Never drop the machine and never try stopping the
chain using the wood or any other obstacle.
If you carry out several cuts without letting go of the
machine, always turn off the machine between cuts.
6.1. HOLDING THE MACHINE
Place the holding belt as shown in the image and click
onto the machine using the ring.