Garland AMAZON 1050 XE, Инструкция по эксплуатации

Страница: 23 / 88

English English
23/88
Water height regulation:
Adjusting the length of the
buoy cable we can adjust
when we want the pump to
start / stop depending on the
water height
It is important to always leave
at least 5 cm of free cable
between the buoy and the
attachment point so that the
buoy has sufficient movement
capacity.
Buoy lock:
You can lock the buoy so that it is
always running by holding the buoy as
indicated in figure 4. This lock is useful
when you want to suck in every last
mm of water.
5.3. CHECKING POINTS BEFORE
SUBMERGING THE PUMP
It is important to check that all parts are well
tightened. Tighten, repair and replace all necessary
before using the machine.
5.4. PUMP SUBMERSION
Place the pump in the water by holding the
transport handle and ensuring the machine is in a
vertical position. The pump can be placed on the
bottom of the surface if the water is clean and has
no impurities. If not, the machine must be placed on
a platform.
If you cannot reach the bottom with your arm, you
can tie a rope to the transport handle and lower the
pump. The same rope can later be used to raise
the pump. Never use the buoy to lower or raise the
pump.
6. MACHINE USAGE
Use this machine only for jobs for which it has
been designed. The use of this machine for any other
jobs is dangerous and can cause dangers to the users
and/or to the machine.
Do not rely solely on the security elements of the
machine.
Do not use this machine if tired, ill or if under the
effects of medicines, alcohol or drugs. The lack of rest
and fatigue can cause accidents and damages.
Do not use this machine at night, with fog or with
reduced visibility that does not allow you to clearly see
the working area.
Always be alert that the machine has no loose parts.
If you detect any loose parts, stop the machine
immediately and check the machine carefully. If you
detect any problems, stop the machine and take to
your nearest service dealer. Never carry on working
with the machine.
6.1. START AND STOPPAGE
The machine starts and stops automatically
depending on the position of the buoy once the
machine has been connected to the mains. This
machine has no manual switch.
6.2. CONNEXION TO THE MAINS
It is obligatory to connect the machine to a mains
switch protected by a residual differential equal
to or less than 30mA. Electricity tension should
be 230v, frequency 50Hz and have a magnet and
thermal switch between 10A-16A.
When using a cable extension, make sure that its
5 cm