Gardner Denver VS-11, Руководство по эксплуатации и обслуживанию

Страница: 15 / 68

13-18-606 Page 14
Lift compressor package by base only. Do not use other places such as
motors, compressors or discharge manifold piping as lifting points.
The eyebolts or lugs provided on the motors are for lifting the motors only and
should not be used to lift any additional weight. All eyebolts must be securely
tightened. When lifting the motors, the lifting angle must not exceed 15
degrees. Failure to observe this warning may result in damage to equipment or
personal injury.
LOCATION - The compressor package shall be installed in a clean, well-lighted, well-ventilated area with ample
space all around for maintenance. Select a location that provides a cool, clean, dry source of air. In some cases
it may be necessary to install duct works to reach a source of adequate cooling air or to direct cooling air in and
out of the compressor package, to prevent recirculation (e.g., hot cooling air entering the fresh air inlet). The
package is designed to operate at ambient temperatures ranging from 40
°
F to 113
°
F (at up to 1000 meter
elevation). Contact Gardner Denver for package operation at conditions exceeding the stipulated values.
A typical ventilation arrangement is shown in Figure 2-2, page 14.
Figure 2-2 – TYPICAL COMPRESSOR ROOM
C
C
C
A
A
A
U
U
U
T
T
T
I
I
I
O
O
O
N
N
N