Gardner Denver INTEGRA AIRSMART EFC99J, Руководство по эксплуатации и обслуживанию

Страница: 61 / 75

13-20-600 Page 60
NOTICE
A sudden drop of zero pressure differential or sudden heavy oil carryover may
indicate a ruptured element.
Inspection - After removal of separator element, shine a light inside the element to reveal areas of heavy
dirt or varnish deposits or breaks (ruptures) in element media.
Removal of Oil Separator For Inspection or Replacement :
Air/oil under pressure will cause severe personal injury or death. Shut down
compressor, relieve system of all pressure, disconnect, lockout and tagout
power supply to the starter before removing valves, caps, plugs, fittings, bolts
and filters.
Compressor, air/oil reservoir, separation chamber and all piping and tubing
may be at high temperature during and after operation.
1. Be certain the unit is off and that no air pressure is in the oil reservoir. The compressor package will
automatically blowdown in about 2 minutes.
2. Close the air service valve located after the compressor package discharge.
3. Disconnect, lockout and tagout the power supply to the starter.
4. Remove the minimum pressure/check valve, see Item 1, Figure 5 6, page 61(air/oil separator
housing) cover.
5. Lift out the air/oil separator element. See Item 2, Figure 5 6, page 61.
6. Inspect and/or replace the separator as necessary.
7. Clean the sealing surfaces on the air/oil separator and the minimum pressure/check valve.
8. Clean the orifice, Item 3, Figure 5 6, page 61, in the oil return line, the strainer, Item 4, Figure 5 6,
page Error! Bookmark not defined. , in the oil return line, and if necessary, the air/oil separator
housing.
9. Grease the O-Ring on the separator element and install the separator into the housing.