HF-7-602 Page 17
SECTION 3
MAINTENANCE
FIGURE 3-1 - LUBRICATION
GENERAL
Blower efficiency and life depend on the quality of maintenance the blower receives. Maintenance must
be done regularly and with care. Clean work space, tools, solvents and wiping rags are necessary to
avoid transferring dirt into the unit. Scheduling regular maintenance of the blower will insure long trouble-
free service.
LUBRICATION
Gears and bearings are splash lubricated by an oil slinger in each sump. Check the oil level in both
sumps daily. Do not operate the blower if the oil level is not in the middle of the sight gauge for each
sump when the blower is not running. An overfill or excess of oil can cause oil leaks.
DO NOT
OVERFILL OIL.
FILLING PROCEDURE
Refer to FIGURE 3-1.
While the blower is not running
remove the plug (B) from each sump. Add oil to
each sump until it reaches the
middle
of each oil level sight gauge (H). After adding oil wait for oil level
to stabilize. Add or remove oil to maintain oil level at middle of oil level sight gauge. Secure the plug (B)
in each end.
LUBRICATION SERVICE
Add fresh oil as required to maintain proper level. The oil change period is governed by operating
conditions such as load, temperature, dirt, humidity, fumes and the quality of the oil used. The oil drain
plug is located at (A). With AEON PD Series synthetic blower lubricant, perform the above oil-change
maintenance after 4500 to 7500 hours.
Do not overfill oil as this will tend to cause excessive heating of the gears and may damage the
unit. An overfill of oil can cause oil leaks.
RECOMMENDED LUBRICANT
Oil Fill Ports
Vertical
Horizontal
Shaft End
2.7
3.6
Gear End
3.0
5.4
Figure 3-2 – APPROXIMATE OIL CAPACITIES (PINTS)
A. Oil Drain Plug
B. Plug/Oil Fill
H. Oil Level Sight
Gauge
Содержание Industrial Series
