![background image](http://html1.mh-extra.com/html/gardner-denver/electra-saver-eau-pd-200-hp/electra-saver-eau-pd-200-hp_operating-and-service-manual_3603248025.webp)
13–10–612 Page 15
MOTOR LUBRICATION – Long time satisfactory op-
eration of an electric motor depends in large measure
on the bearings and timely lubrication. The following
charts show recommended grease qualities and re-
greasing intervals for motors supplied with ball bear-
ings. For additional information refer to the motor
manufacturers instructions.
The following procedure should be used in regreasing:
1.
Stop the unit.
2.
Disconnect, tag and lockout the unit from the pow-
er supply.
3.
Remove the relief plug and free the hole of hard-
ened grease.
4.
Wipe the lubrication fitting clean and add grease
with a hand–operated grease gun.
5.
Leave the relief plug temporarily off. Reconnect
the unit and run for about 20 minutes to expel the
excess grease.
6.
Stop the unit. Replace the relief plug.
7.
Restart the unit.
Rotating machinery can cause injury
or death. Open main disconnect, tag
and lockout power supply to the start-
er before working on the electric mo-
tor.
ELECTRIC MOTOR GREASE RECOMMENDATIONS
Standard
High
Service
Temperature
Worked Penetration
265–296
220–240
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Grease Viscosity, SSU At 100
_
F
400–550
475–525
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Soap Type
Lithium
Lithium
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
N–H Bomb, Minimum Hours For 20 PSI Drop at 210
_
F
750
1000
. . . . . . . . . . . . . .
Bleeding, Maximum Weight % In 500 Hours 212
_
F
10
3
. . . . . . . . . . . . . . . . .
Rust Inhibiting
Yes
Yes
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ELECTRIC MOTOR REGREASING INTERVAL
Type of Service
Typical Examples
Rating
Relubrication Interval
Standard
One– or Two–Shift Operation
Over 150 HP
12 Months
Severe
Continuous Operation
Over 150 HP
6 Months
Very Severe
Dirty Locations, High
Over 150 HP
2 Months
Ambient Temperature
Содержание ELECTRA-SAVER EAU PD - 200 HP
