GARDTEC
580
ENGINEERS MANUAL
Page 26
Resetting After an Alarm
Four reset modes are available after an alarm. These are as follows.
Any Code
The system will reset the next time Any Code is used to set the system.
Master Code
The system will only reset if the Master Code or Engineer code is used to set the sys-
tem.
Engineer Code
The system will only reset if the Engineer Code is used to set the system.
Anti-Code
The system may only be reset by use of an Anti-Code.
To Reset System:-
Enter Code of correct type (see above).
Proceed to set the system.
If a set is not required re-enter the code to abort setting.
To Reset by Anti-Code:-
Make a note of the Code given by the display.
Using the Gardiner Technology Anti-Code software on a P.C enter the four digits given
by the Panel.
The resulting Anti-Code is then entered into the Control Panel to reset it.
Note: This resulting code may also use the YES and NO keys.
580 Eng PR2945.QXD 07/03/01 16:19 Page 29
Technical Manuals Online! - http://www.tech-man.com
