After Sales Support TEL: 1300 130 579 WEB: www.rossmac.com
4
3. Make sure that the shredder is properly
closed (loading funnel and ejector) before
you start up the motor
4. The shredder must be placed on a flat and
firm surface where it can stand securely.
5. Always wear gloves and safety goggles when
working with the shredder.
6. We recommend ear-defenders when working
with shredders which have no noise-
insulating features.
7. Each time before you leave the shredder,
switch off the motor and pull out the ignition
key, spark plug connector or power plug.
8. Maintenance and cleaning work on the
shredder as well as the removal or
adjustment of any safety devices may only be
performed when the motor is at a standstill
and the ignition key, spark plug connector or
power plug has been pulled out.
9. The safety devices supplied with the
shredder (e.g. the ejector) must be used.
10. The shredder must be assembled correctly
before it is put into operation.
11. Examine the shredder each time before
you use it. Do not use the shredder if any
safety devices are damaged or worn. Never
put safety devices out of operation.
12. Use the shredder only for the purpose
specified in these instructions.
13. Work only in good visibility.
14. Always make sure of your footing while
working.
15. Never leave the shredder unattended at
your work place. Store the shredder in a safe
place during interruptions.
16. If you interrupt your work to move to a
different position it is imperative to switch
off the shredder while you are moving there.
17. Never use the shredder in the rain or in
moist or wet conditions.
18. Protect the shredder from the damp and
rain.
19. Always wear suitable clothing to protect
your head, hands and feet from injury. Wear
a helmet, goggles or visor, high boots or
strong shoes, long trousers made of tough
material, and work gloves.
20. Keep the shredder away from other persons,
particularly children and pets.
Caution! The guard is vital for your safety and for
the safety of others, and it is also essential for the
shredder to work correctly. Failure to observe this
instruction will not only create a potential hazard,
it will also result in the loss of your rights under the
warranty.
21. Keep the air vents clear of dirt.
22. After use, unplug the machine and check it for
damage.
23. When you are not using the shredder, keep it in a
dry place out of the reach of children.
24. Check the screws regularly to see that they are
properly tightened.
25. The mains voltage must be the same as the
voltage specified on the rating plate.
26. Plug connectors must be equipped with earthing
contacts and the coupling must be rain-water
protected. It is recommended that an RCD
(Residual Current Device) is fitted into the mains
supply for added safety.
• Do not use 2-core extension leads with power
tools which require an earth - always use 3-core
leads with an earth supply marked for outdoor
use.
• Always unwind any extension reels fully.
• For extension reels up to 15 metres use a wire
cross section of 1.5mm
2
. For extension cords
over 15 metres but less than 40 metres, use a
wire cross section of 2.5mm
2
rated at 10 amps
27. Use only original replacement parts for repair
and maintenance purposes.
28. Have repairs carried out only by a qualified
electrician.
29. Examine the shredder for signs of wear or
damage each time before you use it and after
any collisions. Have essential repairs carried out
without delay.