Gardenline GPHS-26cc, Руководство пользователя

Страница: 15 / 16

Gardenline 15
Turnable handle
Fig. 5
To have good control during operating, the hedge trimmer is equipped with a turnable
handle. The handle can be rotated to several angles: 45° and 90° counterclo 45°
and 90° clockwise.
• Pull the yellow blocking-switch (A) backwards and rotate the handle to the desired angle.
• Release this blocking-switch(A) again and rotate the handle till it clicks into the correct
position. The blocking-switch(A) will automatically return into its original position.
• Check if the handle is now blocked in the new position.
Avoid Hot Surfaces
Keep exhaust area clear of flammable debris. Avoid contact during and immediately after
operation.
Warning! Never perform blade maintenance procedures while engine is running.
Equipment check
Warning! Use only Gardenline approved attachments. Serious injury may result
from the use of a non-approved attachment combination. Gardenline will not be
responsible for the failure of cutting devices, attachments or accessories which
have not been tested and approved by Gardenline. Read and comply with all safety
instructions listed in this manual and safety manual.
• Check hedge trimmer for loose/missing nuts, bolts, and screws. Tighten and/ or replace as
needed.
• Inspect fuel lines, tank, and area around carburetor for fuel leaks. Do not operate hedge
trimmer if leaks are found.
• Inspect shield for damage. Ensure that the blade stiffener is securely in place. Replace if
either is damaged or missing.
• Check that the cutting attachment is firmly attached and in safe operating condition.
• Check that the blade stiffener is not damaged or distorted and replace the blade stiffener if
it is bent or damaged.
3. OPERATION
Fuel Requirements
Gasoline
Use 89 Octane [R+M/2] (mid grade or higher) gasoline known to be good quality. Gasoline may
contain up to 15% MTBE (methyl tertiary-butyl ether). Gasoline containing methyl (wood)
alcohol is not approved.
GB
18 Gardenline
• Set ignition switch(B) to the “I” position (ON position)
• Press priming bulb several times until fuel is visible and flows freely in the clear fuel tank
return line.
• Lock the throttle in the starting position: with the throttle trigger lockout lever (C)
depressed, depress throttle trigger(D) and push lock button(E), then slowly release the
throttle trigger (D) first, then the throttle lockout lever(C).
• Pull recoil starter briskly until the engine runs.
Note: If engine does not start after 5 pulls, use “Cold Start” procedure.
Stopping engine
• Release throttle and allow engine to return to idle before shutting off engine.
• Move ignition switch (B) to “STOP” position.
• In case of emergency, directly set ignition switch to the “STOP” position.
Warning! If engine does not stop when stop switch is moved to Stop position, close
choke -“Cold start” position - to stall engine. Have the address on the warranty card
repair Stop switch before using hedge trimmer again.
Hedge trimming
Fig. 7
• Hold trimmer firmly and squeeze throttle trigger to accelerate engine.
• Tilt trimmer so cutting teeth are angled slightly toward the hedge or shrub and proceed to
cut.
Warning! Never remove hands from hedge trimmer when blades are moving.
Warning! The engine continues running even when the blades have stopped due to
an obstruction. If this occurs, stop the engine, disconnect ignition cable and remove
the obstruction.
4. MAINTENANCE
Your Hedge trimmer is designed to provide many hours of trouble free service.
Regular scheduled maintenance will help your hedge trimmer achieve that goal. If you are
unsure or are not equipped with the necessary tools, you may want to take your hedge
trimmer to the address on the warranty card for maintenance. To help you decide whether
you want to Do-It-Yourself or have the address on the warranty card do it, each
maintenance task has been graded. If task is not listed, see the address on the warranty
card for repairs.
Skill levels
Level 1 = Easy to do. Most required tools come with hedge trimmer.
Level 2 = Moderate difficulty. Some specialized tools may be required.
Level 3 = Experience required. Specialized tools are required. Gardenline recommends
that the hedge trimmer be returned to the address on the warranty card for service.
GB