Gardenline GPHS-26cc, Руководство пользователя

Страница: 14 / 16

Gardenline 19
Gardenline offers Maintenance kits and parts to make your maintenance job easier. Just
below each task heading are listed the various part numbers required for that task. See
the address on the warranty card for these parts.
Maintenance intervals
Service address maintenance procedures
Do-It-Yourself maintenance procedures
Maintenance procedures codes
I = Inspect
R = Replace
C = Clean
(1) = Apply lubrication every 15 - 256 hours of use
(2) = Inspect blade and clean and sharpen as needed. Lubricate blades periodically during use.
* = All recommendations to replace are based on the finding of damage or wear during inspection.
Maintenance
procedure
Inspect/clean/
replace
Inspect/clean
Inspect/replace
Inspect/replace
Inspect/clean
Grease
Inspect/clean
Inspect/clean
Inspect/clean
Inspect/tighten/
replace
Req’d
skill
level
1
2
1
1
2
2
1
1
2
1
Yearly
or 600
hours
-
-
R *
-
-
-
-
-
-
-
6
Months
or 270
hours
-
-
-
-
-
-
-
-
R *
-
3
Months
or 90
hours
R *
-
I
-
-
-
-
-
I C
-
Every
refuel
-
-
-
I
-
-
-
-
-
-
Daily or
before
use
I C
I C
-
I *
I C
I (1)
I C (2)
I C *
-
I R
Component /
System
Air filter
Choke
Fuel filter
Fuel system, leaks
Cooling system
Gear housing
Blades
Recoil starter rope
Spark plug
Screws, nuts, bolts
Maintenance
procedure
Inspect/clean/
decarbon
Inspect/clean
Req’d
skill
level
3
3
Yearly
or 600
hours
-
-
6
Months
or 270
hours
-
-
3
Months
or 90
hours
I C
-
Every
refuel
-
-
Daily or
before
use
-
I (2)
Component /
System
Cylinder exhaust
port
Sharpen blades
GB
14 Gardenline
• Keep your body warm, especially the head, neck, feet, ankles, hands, and wrists.
• Maintain good blood circulation by performing vigorous arm exercises during frequent
work breaks, and also by not smoking.
• Limit the hours of operation. Try to fill each day with jobs where operating the hedge
trimmer or other hand-held power equipment is not required.
• If you experience discomfort, redness, and swelling of the fingers followed by whitening
and loss of feeling, consult your physician before further exposing yourself to cold and
vibration.
Warning! Do not operate this product indoors or in inadequately ventilated areas.
Engine exhaust contains poisonous emissions and can cause serious injury or
death.
Repetitive Stress Injuries
Fig. 3
It is believed that overusing the muscles and tendons of the fingers, hands, arms, and
shoulders may cause soreness, swelling, numbness, weakness, and extreme pain in those
areas. Certain repetitive hand activities may put you at a high risk for developing a Repetitive
Stress Injury (RSI). An extreme RSI condition is Carpal Tunnel Syndrome (CTS), which could
occur when your wrist swells and squeezes a vital nerve that runs through the area. Some
believe that prolonged exposure to vibration may contribute to CTS. CTS can cause severe
pain for months or even years.
To reduce the risk of RSI/CTS, do the following:
•
Avoid using your wrist in a bent, extended, or twisted position. Instead try to maintain a
straight wrist position. Also, when grasping, use your whole hand, not just the thumb and
index finger.
• Take periodic breaks to minimize repetition and rest your hands.
• Reduce the speed and force with which you do the repetitive movement.
• Do exercise to strengthen the hand and arm muscles.
• Immediately stop using all power equipment and consult a doctor if you feel tingling,
numbness, or pain in the fingers, hands, wrists, or arms. The sooner RSI/CTS is
diagnosed, the more likely permanent nerve and muscle damage can be prevented.
Clear the work area
Fig. 4
Spectators and fellow workers must be warned, and children and animals prevented from
coming nearer than 15 m (50 ft.) while the hedge trimmer is in use.
Keep a firm grip and a solid stance
Fig. 4
• Hold the front and rear handles with both hands, with thumbs and fingers encircling the
handles.
• Maintain footing and balance at all times. Do not stand on slippery, uneven or unstable
surfaces. Do not work in odd positions or on ladders. Do not over reach.
GB