Preparations
18
6. From the outside, put a 8.5/15.5 mm washer
34
onto the screw.
7. Use two wing nuts
33
to tighten the two screws.
8. Install the pull starter bracket
38
on the upper handle by inserting the M8 × 45
mm
39
screw through the upper handle, the pull starter bracket and the ∅ 6.4 /
18 mm
36
washer from the outside (see
Fig. K
).
9. Use the M6 domed cap nut
37
to tighten the screw.
10. Hold down the bail control arm
16
and then pull the pull starter
14
out a little bit.
11. Guide the starter cord
13
through the pull starter bracket in order to hang the
starter rope in the pull starter bracket.
12. Use a cable tie
4
to secure the Bowden cable to the lower handle and another
cable tie to secure it on the upper handle (see
Fig. A
).
Inserting the grass catcher bag
1. Lift the flap
6
all the way up (see
Fig. L
).
2. Attach the installed grass catcher bag
5
to the bracket on the lawn mower.
3. Make sure that you hear the grass catcher bag lock into place.
4. Lower the flap onto the grass catcher bag.
Preparations
WARNING!
Risk of injury!
Improper preparation may result in danger situations and injury.
− Stop the motor, unplug the spark plug and make sure all moving parts have
come to a complete stop before you begin preparing to use the lawn mower.
Fuel
DANGER!
Risk of explosion, fire and damage to health!
Petrol and oil are highly flammable. Improper handling of fuels may lead to an
explosion or a fire and can thereby damage your health through improper use.
− Keep the lawn mower away from open flames and do not smoke when
adding fuel.
