5
Helpline No. UK / N.IRELAND 0845 603 9277 Rep. Ireland 1890 8823 74
Web Support www.gardenhomepower.com
Model Number: EL 600 Electric Raker
2.3. Electrical safety
• The mains voltage must correspond to the one marked on the tool’s
rating label (230V ~50Hz). Do not use other sources of power.
•
For the power supply line, the use of a protective switch (circuit-breaker)
with a nominal breaking current in the range to 30mA is recommended.
Consult a qualifi ed electrician.
•
Never pass the running tool over the extension cable to which it is
connected, as this could cut the cable. Make sure that you always know
where the cable is.
•
Use the special cable holder (strain relief) for the connection of the
extension cable.
•
Never use the tool when it is raining. Try to prevent it from getting wet or
being exposed to humidity. Do not leave it outside overnight.
•
The power supply cable should be checked regularly and before each
time it is used; make sure that the cable is not damaged or worn out.
If the cable is not in good condition, do not use the tool; take it to an
authorized service centre instead.
•
Only use extension cables that are suitable for outdoor use. Keep it away
from the cutting area, from damp, wet or oily surfaces or surfaces with
sharp edges and also from heat and fuels.
•
The mobile socket of the extension cable should be splash proof in
compliance with the requirements of DIN 57282 and VDE 0282; the cross-
section of the wire (max. length: 75m) should be at least 1.5mm2. Use
H07RN-F harmonized cable.
3.
Names of parts
1
GB
1.
Safety switch/plug combination
2.
Trigger lever
3.
Cable strain relief
4.
Guide bar, upper section
5.
Grass collector bag
6.
Guide bar, lower section
7.
Spring system
8.
Height adjustment
4. Before starting up
4.1. Intended use
This tool is only intended as an electric raker for use in domestic and hobby
gardens.
It is not designed for use in public areas, parks, sports facilities, or in
agriculture and forestry. Using the tool for any other purpose is considered
improper and therefore not approved. The manufacturer is not liable for any
damage or injury resulting from such improper or not approved use. The
user is fully liable for any risks associated with such use.
4.2. Double insulation
The electric raker has double insulation. This means that all external metal
parts are insulated from the electric power supply. This is achieved by
introducing an insulation layer between the electrical and mechanical parts.
The double insulation guarantees you the greatest possible safety.
4.3. Overheat protection
If the tool is blocked by a foreign object or if the motor is overloaded, the
motor will be automatically switched off by the protection device. Release
the trigger level and wait until the motor has cooled down (approx. 15
minutes), then start the tool again.
8
3
5
7
6
4
1
2
Содержание EL 600
Страница 2: ......
