AFTER SALES SUPPORT
1300 922 271
MODEL NUMBER: BG-EC 620T, 11/11
15
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level
83 dB(A)
K
pA
uncertainty
1 dB
L
WA
sound power level
103 dB(A)
K
WA
uncertainty
3 dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle under load
Vibration emission value ah = 3.47 m/s
2
K uncertainty = 1.5 m/s
2
Warning!
The specified vibration value was established in
accordance with a standardised testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect condition.
•
Maintain and clean the equipment regularly.
•
Adopt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
•
Wear gloves.
Maintenance
8
Important!
Always disconnect the mains plug before
performing any checks or adjustments. Always wear
protective gloves when working on the pruner to
protect yourself against injury.
8.1 Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if the guide groove
of the cutter rail is worn. Proceed as described in
Section 4.2.
8.2 Checking the automatic chain lubrication
You should check the operation of the automatic chain
lubrication system on a regular basis in order to guard
against overheating and the associated damage to the
cutter rail and the saw chain.
Important!
Do not actually touch the surface with the
tip of the cutter rail when performing the following
test. Keep a safe distance (approx. 20 cm).
To check the automatic chain lubrication, point the tip
of the cutter rail towards a smooth surface (board,
section of a cut tree) and allow the pruner to run. If an
increasing oil trace becomes evident during this process
then the automatic chain lubrication system is working
properly. If no clear oil trace is evident then please refer
to the corresponding instructions in “Troubleshooting”.
If the information contained there still fails to remedy
the situation then please contact our After Sales
Support on 1300 922 271 or another similarly qualified
workshop.
8.3 Sharpening the saw chain
Effective working with the pruner is only possible if
the saw chain is in good condition and sharp. This
also reduces the risk of kickback. The saw chain can be
re-sharpened by any dealer. Do not attempt to sharpen
the saw chain yourself unless you have the necessary
special tools and experience.
8.4 Power Cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its aftersales
service or similarly trained personnel to avoid danger.
Cleaning and Storing
9
Important!
•
Always disconnect the mains plug before cleaning
the pruner.
•
Never immerse the unit in water or other liquids
in order to clean it.
•
Store the pruner in a safe and dry place out of the
reach of children.
•
Always wear protective gloves when working on
the pruner to protect yourself against injury.
•
Regularly clean the clamping mechanism by
blowing it out with compressed air or cleaning it
with a brush. Do not use tools for cleaning.
•
Keep the handles free of grease so that you can
maintain a firm grip.
•
Clean the equipment as required with a damp
cloth and, if necessary, mild washing up liquid.
