S
U
A
1800 909 909
www.powertoolsupport.com email: [email protected] 11/2015
AFTER SALES SUPPORT
50714
13
Fitting the Collection Bag
WARNING
Never operate the vacuum without collection bag attached.
Serious personal injury could be the result if the blower vac is used without the
bag fitted.
IMPORTANT
Before using this appliance as a vacuum, ensure the correct vacuum
tubes are in position as per the instructions on the previous page, and the
collection bag zip is done up before fitting.
Note.
Always make sure the collection bag (11) zipper is closed when the vacuum
function is in use.
For use as a vacuum, the collection bag (11) must be fitted.
The collection bag (11) fits on to the discharge port (22) of the
blower vac housing, where the blow tubes are fitted when
used in blowing operation. If the blow tubes are fitted, these
need to be removed. Remove the two toolfree screws, rotate
the tube as far as possible and then pull the tube off the
blower. (Fig N)
1. Align the collection bag tube (8) to the
outlet of the vac. Push the collection bag
tube (8) onto the outlet housing as far as
possible. (Fig O).
2. Rotate the tube until the retaining holes
align. Check the orientation of the tube to
ensure the tube is pointing downward and
NOT upward. (Fig P). If upward rotate the
tube in the reverse direction to assembly, and remove from
vac. Turn the tube 180° and refit. Again, check the orientation
of the tube (8) with the pic.
3. Fit the two toolfree screws to hold the collection tube in place.
(Fig Q)
Note.
If your collection bag becomes worn, replacement bags
are available for purchase. Please refer to page 23 for further
detail.
Note.
To remove the collection bag, follow the above instructions in reverse.
Instructions
5
N.
P.
Q.
O.
