Gardenic VC400ECH, Инструкция по эксплуатации

Страница: 6 / 86

EN
Clean and store the pump in a frost-free place before the first frost arrives.
TROUBLE-SHOOTING
Problem Probable cause Remedy
Pump is running . but doesn’t
dellver Air cannot escape , since
pressure line is closed Open pressure line (e.g.
kinked pressure pipe)
Air locks in the suction base Wait for max 60 seconds
until the pump deaerates
automatically over the vent
valve. ,if necessary , switch
off and start it again.
Turbine clogged Disconnect plug and clean
turbine
When starting the pump ,
water height falls below the
min, water level Submerge pump deeper
Pump doesn’t start or
suddenly stops during
operation
Thermal overload switch has
switched the pump off due to
overheating . Disconnect plug and clean
turbine
Observe
max , media
temperature of 35
℃
No power Check fuses and electric
connections
Dirt particles are jammed in
the suction base Disconnect plug and clean
suction base
Pump runs , but output
suddenly decreases Suction base is clogged. Disconnect plug and clean
suction base
RECYCYLING
When your pump is broken, do not throw it anywhere: make a simple gesture for
the environment.
Bring your pump to a collection center of electrical appliances so that it can be
effectively retired in the chain of proper waste disposal.
Recycle unwanted materials instead of disposing of them. All appliances and
packaging should be sorted and tendered at a regional recycling centre into to be
processed in an ecological manner.