34
(2) Lock nut
█
INSTALLING THE METAL BLADE(F5)
1. Set the inner holder to the gear shaft, and turn to fix with the attached L-
shaped bar.
2. Put the blade on the inner holder with letters to the gear case, and match
correctly the hole of the blade to the projection of the inner holder.
3. Set the outer holder to the gear shaft with the hollowed face to the blade.
4. Put the attached cover on the outer holder and
secure it with the bolt (left hand tread) together
with the spring washer and the washer.
(1) Nut
(2) Protect cover
(3) Flung spindle
(4) Blade Brush 3 tooth
(5) Ring
(6) Holder
(7) Key
(8) Inner holder
(9) Gear case
█
INSTALLING THE NYLON CUTTER(OPTION)(F6)
1. Set correctly the inner holder and the outer
holder to the gear shaft.
2. Screw the attached holder (M8 left) into the
gear shaft and
Secure it with the spanner.
3. Screw the nylon cutter into the bolt by fixing
the inner holder with the L-shaped bar and
tighten it manually.
Keep bolts and washers to install the blade carefully so as not to lose them.
(1) Gear case
(2) Bolt
(3) Nylon cutter
(4) Nylon cord
6. FUEL
＊
Gasoline is very flammable. Avoid smoking or
bringing any flame or sparks near fuel.
＊
Wipe up all spills before starting the engine.
＊
Make sure to stop the engine and allow it to cool
NOTE
WARNING
IMPORTANT1
