
English - 25
INSTALLATION
Laying the boundary wire
If you intend to peg down the boundary wire:
•
Cut the grass very low with a standard lawnmower
or a trimmer where the wire is to be laid. It will then
be easier to lay the wire close to the ground and
the risk of the robotic lawnmower cutting the wire
or damaging the insulation of the wire is reduced.
•
Make sure to lay the boundary wire close to the
ground and secure the pegs close together. The
cable must lie close to the ground so as not to be cut
before the grass roots have grown over it.
•
Use a hammer to knock the pegs into the ground.
Exercise care when knocking in the pegs and make
sure the wire is not under strain. Avoid sharp bends in
the wire.
If the boundary wire is to be buried:
•
Make sure to lay the boundary wire at least 1 cm and
a maximum of 20 cm in the ground. The wire can be
buried for instance using an edge cutter or a straight
spade.
Use the supplied measurement gauge as a guide when
you lay out the boundary wire. This helps you to easily set
the correct distance between the boundary wire and the
boundary/obstacle. The measurement gauge is broken
loose from the box.
IMPORTANT INFORMATION
Extra wire must not be placed in coils
outside the boundary wire. This can
disrupt the robotic lawnmower.
Eyelet for connecting the guide wire
To facilitate the connection of the guide wire to the
boundary wire, it is recommended to create an eyelet with
about 20 cm of extra boundary wire at the point where the
guide wire will later be connected. It is a good idea to plan
where the guide wire will be placed before laying out the
boundary wire.
See 3.6 Installation of the guide wire on
page 28
.
3018-085
3012-281
3023-007
1157808,Gardena_R100Li-R130Li,GB_151217.indd 25
2016-01-12 09:16:18