![background image](http://html1.mh-extra.com/html/gardena/procut-1000/procut-1000_operating-instructions-manual_562960005.webp)
14
GB
Try to ensure that the cutting filament does not come into
excessive contact with hard objects (walls, stones, fences
etc.) to prevent the filaments fusing together or snapping.
1. Fit the carrying strap
D
into
the hole
E
(ProCut 1000,
3 holes).
2. Put the strap
D
around you and
adjust it to your size.
3. Hold the trimmer by the top
of the handle
A
and the addi-
tional handle
F
or handle
5
so that the cutting head
3
is
tilted slightly forward.
ProCut 800 only :
1. Undo the tightening nut
G
,
push the additional handle
F
into the required place and
tighten the nut
G
by hand.
2. Press the push buttons
H
on both sides. Set the additional
handle to the required angle
F
and release the push buttons
again.
Switching the trimmer on :
1. Press and hold the safety
lock
I
and then press the
start button
J
on the handle.
2.
Release the safety lock
I
again.
Switching the trimmer off :
v
Release the start button
J
on the handle.
The tap mechanism works when the motor is running. A clean
cut is only achieved with the maximum filament length.
1. Start the trimmer.
2. Hold the cutting head
3
parallel to the ground and
tap the trimmer with the
cutting head
3
on the
ground (avoid sustained
pressure).
The cutting filaments
1
lengthen automatically with an audible
switching sound. The filament limiter
K
adjusts the filament to the
correct length. If necessary tap several times one after the other.
Starting the trimmer :
Filament feed
(Tap mechanism) :
Put the trimmer in the
working position :
I
J
I
J
K
1
3
D
F
G
A
E
H