Gardena powerCut 2404, Руководство по эксплуатации

Страница: 6 / 12

13
GB
Risk of injury !
Pulling the filament
out of the filament cassette :
L
K
E
5. Trouble-Shooting
Risk of injury from the cutting filament !
V
Always unplug the mains plug of the Turbotrimmer be-
fore troubleshooting.
If a filament is drawn into the filament cassette you can pull it out
again as described below.
1. Unplug the mains plug.
2. Remove the filament cassette as described under 4. Mainte-
nance “Replacing the filament cassette” .
3. Press together the plastic ring
L
on the filament cassette
E
between your thumb and forefinger.
4. Draw the plastic ring
L
with the thumb of the other hand over
the side part of the filament cassette
E
(use a screwdriver
if necessary). You can now access the filament that was drawn
into the filament cassette.
5. Unwind the filament
K
approximately 10 cm and thread
it through the eye of the plastic ring
L
. If ne-
cessary, loosen the filament beforehand
using a screwdriver. The filament
K
may stand out max. 2 cm over the knife
F
.
6. Pull the plastic ring
L
back over the
filament cassette
E
.
7. Reinstall the filament cassette as described
under 4. Mainte-nance “Replacing the
filament cassette”.
Only GARDENA Service Centres and authorised specialist
GARDENA dealers may carry out repairs.
Fault Possible cause Remedy
The Turbotrimmer Filament worn or too short.
v
Lengthen the filament –
no longer cuts. see 3. Operation “Filament
feed (Tip mechanism for
automatic filament feed )”.
Filament cassette empty.
v
Replace the filament cassette
– see 4. Maintenance
“Replacing the filament
cassette” ).
Filament drawn into the
v
Pull the filament out of the
cassette or stuck together. filament cassette (see above).
If you have any other problems please contact the GARDENA Customer Service.
6. Storage
The Turbotrimmer must be stored out of the reach of children.
v
Store your Turbotrimmer in a dry place where it is protected
from frost.
Recommended storage :
We recommend that you hang your Turbotrimmer from the cable
lock. Hanging storage helps avoid unnecessary stress on the
cutting head.
F
L
E
Overwintering :