5. STORAGE
To put into storage [ Fig. S1 ]:
The product must be stored away from children.
1. Remove the battery.
2. Charge the battery.
3. Turn the pump upside down to allow residual water to
flow out.
4. Clean the pump, the battery holder, the battery and the
battery charger (see 4. MAINTENANCE).
5. To save storage space, fold in the bracket and slide the
battery holder
(11)
from above onto the intended holder
on the pump.
6. Store the pump, the battery and the battery charger in
a dry, enclosed and frost-free place.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal
household waste. It must be disposed of in line
with local environmental regulations.
IMPORTANT!
Dispose of the product through or via your municipal
recycling collection centre.
Disposal of the battery:
Li-ion
The GARDENA battery contains lithium-ion
cells that should not be disposed of with
normal household waste at the end of its life.
IMPORTANT!
Dispose of the batteries through or via your municipal
recycling collection centre.
1. Discharge the lithium-ion cells completely
(contact the GARDENA Service).
2. Protect the contacts on the lithium-ion cells against
short circuits.
3. Dispose of the lithium-ion cells properly.
6. TROUBLESHOOTING
Problem
Possible Cause
Remedy
Pump is running,
but doesn’t deliver
Air cannot escape, because the
pressure line is closed.
(Possible kink in the pressure hose.)
v
Open the pressure line (e. g. shut-off
valve, delivery units).
Air in suction foot.
v
Wait for about max. 60 seconds until
the pump has vented; if necessary,
switch off / on several times if neces-
sary. If this does not help briefly start
the pump in the water once without
the hose.
Foot / Filter is clogged.
v
Clean the foot / filter.
Water level below minimum water
level when put into operation..
v
Submerge the pump deeper.
DANGER! Risk of injury!
Injury when the product starts accidentally.
v
Remove the battery before you troubleshoot the
product.
1. Turn the foot
(9)
anti-clockwise and remove the foot
(9)
(bayonet lock).
2. Turn the filter
(10)
anti-clockwise and remove the filter
(10)
(bayonet lock).
3. Clean the filter
(10)
and the foot
(9)
under running water.
4. Push the filter
(10)
into the pump so that the lines
ß
a1
/
ß
a2
are opposite.
5. Turn the filter
(10)
anti-clockwise (bayonet lock).
6. Push the foot
(9)
onto the pump so that the lines
ß
a1
/
ß
a3
are opposite.
7. Turn the foot clockwise (bayonet lock).
The pump must not be operated without the filter
(10)
.
To clean the battery, the battery holder and the
battery charger:
Make sure that the surface and the contacts of the battery,
the battery holder and the battery charger always are clean
and dry before you connect the battery charger.
Do not use running water.
v
Clean the contacts and the plastic parts with a soft and
dry cloth.
EN
16
